Remove the quick release pin from the bottom of the deployment pole.
Insert the camera head mounting into the pole-aligning pin holes and reinstall the pin to secure the camera.
Install the battery housing assembly onto the thinnest section of the telescoping pole. It’s recommended to install the housing between the pole and depth rod to minimize the footprint for tight spaces.
Install the coil cable between the camera head and battery housing. If utilizing the housing orientation in Step #3, it’s recommended, to pass the coil cord through the opening in the depth rod arm (between the depth rod and pole).
Unlatch the housing lid, open, and install the battery. Close the lid and secure with the latch.
Adjust the camera tilt position to the desired location. The same adjustment ball can be used to rotate the position of the camera head, as well.
Press the power button on the rear of the camera head to begin the operation (the switch is touch-sensitive and will not move in/out).
Comments
0 comments
Article is closed for comments.